User Guide
34
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
CAUTION: Do not power off the switch or computer being used during
the upgrade or the switch may be damaged. During upgrade,
it is recommended to disable all network connections
except the network connection of the computer used for
the upgrade.
5.13.5 IP Confi guration
Confi gure IP Address
DHCP Client: Enables or disables the DHCP client. It is disabled by default.
IP Address: Sets the login IP address of the switch (192.168.0.3 by default)
Subnet Mask: Sets the subnet mask of the switch (255.255.255.0 by default)
Gateway: Sets the gateway of the switch (0.0.0.0 by default)
Management VLAN: Selects the VLAN of the management computer
NOTE: If the Management VLAN is not setup properly, you will not be
able to manage the switch.
CAUTION: After enabling the DHCP client, you must check for the IP
address obtained from the DHCP server (usually a router or
sever in the network) and then re-connect to the switch. It is
not recommended to use this function.
5.13.6 MAC Aging
The default MAC address aging time is 300 seconds. The set value should be
between 10 seconds and 65535 seconds. Otherwise, the system will report an error.
If “ARL Aging” is left unchecked, the system terminates MAC address aging (not
recommended).
To Next Page
Loading...
Need help?
General
