User Guide
32
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
5.13 System
5.13.1 SNMP
5.13.2 Change Password
5.13.3 Power Save
5.13.4 Upgrade
5.13.5 IP Confi guration
5.13.6 MAC Aging
5.13.7 Restore Factory
Defaults
5.13.9 Restore
5.13.10 Logout
5.13.1 SNMP
All management information and counters are stored in the Management
Information Base (MIB) of the switch. The XMS-1008P adopts standard MIB-II
modules that support read function from any SNMP-based NMS software. MIB data
may be set to either read-only or read-write mode.
The default SNMP community names of the switch can be user modifi ed.
Traps are messages generated by the XMS-1008P and used for notifi cation of
certain events. Such events may be serious (i.e. switch reboot) or ordinary (i.e.
the status changes of a switch port). The XMS-1008P can generate traps and send
them to the NMS.
SNMP Confi guration
SNMP: Enables or disables the SNMP management function. SNMP is enabled by
default
SNMP Trap Destination: Sets the destination IP address of the Trap messages
generated by the XMS-1008P
SNMP Read Community: Sets the read-only community name. For a device to
read the SNMP information of the XMS-1008P, the SNMP management software
must contain the read-only community name
SNMP Write Community: Sets the read/write community name. For a device
to modify the SNMP information on the XMS-1008P, the SNMP management
software must contain the read/write community name
SNMP Trap Community: Used by the SNMP management software to identify
the switch sending the Trap message
To Next Page
Loading...
Need help?
General
