User Guide
36
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
5.13.9 Restore
Restore Settings from a File: Restores the backup switch confi guration. Click
“Browse” and select the backup fi le on your computer, and then click “Restore”.
CAUTION: It takes about 30 seconds to complete the restoration. To
avoid errors during the restoration, do not power off the
switch or computer being used. At the end of restoration,
you will need to restart the switch.
5.13.10 Logout
This function is used to exit the switch confi guration.
6: REGULATORY COMPLIANCE
This device is approved under the Luxul brand and designed to comply for use spe-
cifi cally with other approved Luxul devices. This device is designed to be compliant
with rules and regulations in locations where they are sold and will be labeled as
required. Any changes or modifi cations to Luxul equipment, not expressly ap-
proved by Luxul, could void the user’s authority to operate the equipment. This
Luxul device when used in conjunction with the approved Luxul Models should be
professionally installed and the Radio Frequency Output Power will not exceed the
maximum allowable limit for those countries that have regulatory approval.
6.1 Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with
regard to the usage of wireless devices
Potentially Hazardous Atmospheres: You are reminded of the need to observe
restrictions on the use of radio devices in fuel depots, chemical plants etc. and areas
where the air contains chemicals or particles (such as grain, dust, or metal powders).
Safety in Hospitals: Wireless devices transmit radio frequency energy and may
affect medical electrical equipment. When installed adjacent to other equipment,
it is advised to verify that the adjacent equipment is not adversely affected.
Power Supply: Use only a Luxul approved power supply output rated at 100-240VDC
and minimum 0.6A. The power supply shall be Listed to UL/CSA 60950-1; and
certifi ed to IEC60950-1 and EN60950-1 with SELV outputs. The device can also
be powered from a compliant POE source. Use of alternative power supply will
invalidate any approval given to this device and may be dangerous.
To Next Page
Loading...
Need help?
General
