Document Name:
LX Eos user’s manual
17 Upload Task on LX Eos
The user can transfer the Task to LX Eos using two ways:
- With a microSD as explained in chapter 12.10.2 "Load TSK" in relation to TPs and their view zone.
- With a PDA connected to User port or via Bluetooth. This way the user can only send the IGC declaration
according to FAI rules. They will be transferred to LX Eos the TPs and the view zone of the start line
and of the finish line. A standard FAI view zone (90°) will be assigned to all intermediate TPs.
The user can later change, if necessary, the view zone directly in Task page of LX Eos (see Chaper.9).
18 Installation of the unit
18.1 Mechanical installation
LX Eos fits in standard 57mm hole in instrumental panel so no extra cut out is required. To fit LX Eos in
instrumental panel unscrew three mounting screws (black) with a screwdriver and knob of rotary switch. To
remove the knob do not use force. Remove the press-in cover first to get to the screw. After unscrewing
the screw pull off the knob. Place the LX Eos in the hole in instrumental panel and first screw in the three
black screws and then put back the knob on the rotary switch. Don’t forget to screw the knob in place and
put the press-in cover back on.
To Next Page
Loading...
