LX Navigation LX Eos 57 - 23 Revision History

Document Name:
LX Eos user’s manual
Version: 1.7
Page 47 of 47
23 Revision history
Date
Version
Changes
9.2.2015
1.1
- corrected pinout on Flarm and user port.
- GPS antenna connector description.
- hardware specification added.
- max number of TPs imported in unlimited.
- added wind calculation paragraph
11.3.2015
1.2
- small text corrections.
- added TA beep under Vario/SC menu.
- added SpeedToFly, Vario relative, FG, Distance options under Indicators menu.
- added Load TSK under SD Card menu
- added gear and airbrakes input
- added input warning under Warnings menu
- added KTR2 support under NMEA menu.
- Load TP chapter has warning based on large CUP TP base import.
- added external switch description and connection diagram for 1wire and 2 wire
connection.
- added Bluetooth module chapter.
- added User port chapter.
- added Configurations chapter.
- when using select option for TP, number of TPs found is displayed on header.
- task distance with task type is shown under TASK SETUP
14.5.2015
1.3
- Updated Flarm radar page.
- changed TA page layout.
- added Flarm options under Voice menu.
16.5.2015
1.4
- Max beep is found under Vario/SC menu.
- TP and TSK are displaying final glide with bigger numbers.
- Added Flarm warning chapter.
- added password for user settings under Setup/Pilot
- user settings can be imported/exported to/from SD card under Setup/Pilot menu.
- added audio player password
21.8.2015
1.5
- user can control volume in vario mode and SC mode independently. Mode is
written down on Volume control box.
- added password 66666 - clear actual task.
- added password 55555 - clear TP database.
- input can be inverted in case of inverted switch - active open state.
- non directional object is shown on Flarm radar as red circle.
- ADSB objects are displayed as green triangles on Flarm radar.
- setup menu on TA page.
- removed TA beep setting from Vario/SC menu.
- removed Auto TA setting from Page menu.
- audio frequency (negative, zero and positive) can be set under Vario/SC menu.
- added “Upload Task on LX Eos” chapter.
- added Wiring for radio chapter.
10.8.2016
1.6
- added shutdown option in menu.
- added g-Force page.
- added g-Force as needle select.
- added test audio in vario/SC menu
- added transponder option in NMEA menu.
11.10.2017
1.7
- added ballast dump setting.
- added info page.
- added vario silence and max SC speed setting.
- added input status.
- added pre-set elevation setting.
- added altitude sensor setting.