6 Magellan GPS ColorTRAK
Installing the Batteries
The GPS ColorTRAK uses four AA alkaline batteries that are installed from
the bottom of the receiver. Use the rings to unscrew the water seal battery
caps. Insert the batteries into the battery tubes, with the positive end first,
two batteries in each side, and screw the battery caps until securely closed.
It is recommended that four batteries be used, however, in case of an
emergency, the receiver will operate with only two batteries if both are
inserted into one of the battery tubes.
If the batteries are left out of the unit for more than 30 minutes,
the unit may need to be reinitialized.
+
+
+
+
-
-
-
-
GPS ColorTRAK
To Next Page
Loading...
