Magic Mobility R-NET CJSM2 User Manual

r-net user guide
28 5940A R-net User Guide DCR1266 magicmobility.com.au
charger connector resulting in overheating of the charger plugs. This presents a potential burn hazard for
the user.
Ensure that the charger plug pins are of the correct polarity to be compatible with the pin polarity shown
on the control system’s specific data sheet. Failure to observe this condition could result in a burn hazard
or fire hazard.
Do not disconnect batteries or open-circuit the circuit breaker while charging is in progress. Failure to
observe this condition could result in a burns hazard or fire hazard.
Only use the battery charger that has been supplied with your wheelchair. The use of incorrect chargers
could damage the batteries, wheelchair, control system or charger itself, or may result in parts
overheating creating the potential for burns or even fire.
14 PROGRAMMING
The control system can be programmed to meet your needs. Programming can be performed using the OBP
(On-board Programming) feature or the specialist R-net software and Dongle or the Diagnostic Test Tool
(DTT).
WARNING:
Programming should only be conducted by your Magic Mobility Representative with in-depth knowledge
of R-Net electronic control systems. Incorrect programming could result in an unsafe set-up of a
wheelchair for a user.
15 SERVICING
All repairs and servicing must be carried out by authorised service personnel. Opening or making any
unauthorized adjustments or modifications to the control system or its components will invalidate any
warranty, may result in hazards to yourself or other people and is strictly forbidden.
WARNING:
If the control system is damaged in any way, or if internal damage may have occurred through impact or
dropping, have the product checked by qualified personnel before operating.
16 WARRANTY
The R-net control system is covered by a warranty period defined by the wheelchair manufacturer. For details
of the warranty period, please contact your service agent.
The warranty will be void if the R-net control system has:
Not been used in accordance with the R-net control system Technical Manual, SK77981.
Been subject to misuse or abuse.
Been modified or repaired by non-authorized persons.
WARNING:
The warranty will be void if the R-net has not been used in accordance with this User Guide, the R-net has
been subject to misuse or abuse, or if the R-net has been modified or repaired by unauthorised persons.

Magic Mobility R-NET CJSM2 Specifications