Magic Mobility R-NET CJSM2 User Manual

r-net user guide
35 5940A R-net User Guide DCR1266 magicmobility.com.au
3.11 Maximum speed / Profile indicator ripples up and down
This indicates the control system is locked, refer to Chapter 1 section 5.4 for details of how to unlock the
control system.
3.12 Maximum speed / Profile indicator flashes
This indicates the speed of the wheelchair is being limited for safety reasons. The exact reason will depend on
the type of wheelchair; however, the most common cause is that the seat is in the elevated position.
4 GETTING READY TO DRIVE
Operate the On/Off switch. The battery gauge will blink then remain on after a few seconds.
Check that the maximum speed control is set to a level that suits you.
WARNING:
If you push the joystick before or just after you switch the control system on, the battery gauge will ripple
up and down. You must release and centre the joystick to resume normal operation. If you do not release
the joystick within five seconds the wheelchair will not be able to move, even if you release the joystick
and push it again. The battery gauge will flash 7 LEDs at this time. You can reset this condition by
switching the control system off and on again. Refer to section 3.
If the battery gauge flashes rapidly, then the R-net has detected a problem somewhere in the wheelchair’s
electrical system. Refer to section 3 for details.

Magic Mobility R-NET CJSM2 Specifications