EasyManua.ls Logo

Magic Vac Jumbo - Troubleshooting Common Operational Issues

Magic Vac Jumbo
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
The MAGIC VAC
®
does
notwork
The MAGIC VAC
®
fails
toapplytherstsealon
thebagcutfromtheroll
The MAGIC VAC
®
does
not create a complete
vacuuminthebags
The MAGIC VAC
®
does not seal the bag
properly
The MAGIC VAC
®
bag
does not maintain a
vacuum after being
sealed
The MAGIC VAC
®
does
notcreateavacuumin
thecontainers
MAGIC VAC
®
Executive
containers or MAGIC
VAC
®
UniversalCapsdo
notmaintainavacuum
The marinating cycle
doesnotstartproperly
•Checktheswitch(1) position.
•CheckthattheMAGICVAC
®
powersupplycordispluggedintotheapplianceandintothe
electricaloutlet.Checktheelectricoutletbyplugginganotherunitintoit.
•Checkforfaultsinthepowercordortheplug.Shouldyoudetectafault,donotusethe
appliance.
•Makesurethebagcutfromtherollisproperlypositionedasdescribedintheparagraph:
“5-MakingbagsfromMAGICVACrolls
®
•Makesurethatthesealinggasketisintactandinthecorrectposition
•Tosealthebagproperly,youmustmakesurethattheopenendremainscompletelyinside
the Vacuum Chamber.
•MakesurethattheSealingBarandtheAirtightandSealingGasketsarefreeofimpurities.
Aftercleaningthem,putthemproperlybackinplace.
•TheMAGICVAC
®
bagmighthaveaholeinit.Tocheckthebag,sealitwithairinside,placeit
underwaterandapplypressureonit.Theappearanceofbubblesmeansthatthereisaleak.
Resealoruseanotherbag.
•Whenevertheappliancedoesnotsealthebagcompletely,pressthe“T”button(2F) and
increasethesealingtime.
•IftheSealingBaroverheatsandmeltsthebag,youmayhavetoraisetheLidandallowthe
SealingBartocooldownforafewminutes.
•Makesurethatthesealinggasketisintactandinthecorrectposition
•Leaksalongtheseammaybecausedbycreases,crumbs,greaseorliquids.Reopenthe
bag,cleantheupperinsidepartofthebagandremoveanyforeignmaterialfromtheSealing
Barbeforeresealingit.
•Checkthatthebaghasnoholesinitwhichhavecausedairtoleakin.Usepapernapkinsto
protectanysharpedgesonthecontentsofthebag.
•BymeansoftheConnectionHose,connectthecontainercap(ortheCapAttachmentif
necessary) to the Air Inlet of the appliance.
•Leaveenoughroom(atleast3cm)betweenthecontentsandthetopofthejarorcontainer.
•Ifliquidscomeoutduringthevacuum-packingprocess,rememberthattheymustrstbe
chilledinarefrigerator.
•Check that the rim of the jar or container and the universal cap arenotdamagedinthe
sealingarea.Wipetherimandcapcleanwithaclothmoistenedwithlukewarmwaterand
repeatthevacuum-packingprocess.
•Makesurethatthegasketofthecontainercaportheuniversalcapissetproperlyinplace
andisnotdamaged.
•Make surethatthearrowontheknobofthe container cap ispositionedon“VACUUM”
beforecreatingavacuuminthecontaineranditispositionedon“CLOSED”afteravacuum
is formed.
•MakesurethattheO-ringbeneaththeknobofthecontainercaportheuniversalcapisset
properly in place.
•Check that the rim of the jar or container and the universal cap arenotdamagedinthe
sealingarea.Wipetherimandcapcleanwithaclothmoistenedwithlukewarmwaterand
repeatthevacuum-formingprocess.
•Makesurethatthegasketofthecontainercaportheuniversalcapissetproperlyinplace
andisnotdamaged.
•Makesurethattheconnectiontubeisproperlyconnectedtoboththecontainerknoband
the air inlet (4) of the appliance.
•Makesurethatthearrowontheknobofthesquarecontainercapispositionedon“OPEN-
(M)”andsafetycatches(21)areengaged.
•MakesurethattheO-ringbeneaththeknobofthecontainercaportheuniversalcapisset
properly in place.
•Check that the rim of the jar or container and the universal cap arenotdamagedinthe
sealingarea.Wipetherimandcapcleanwithaclothmoistenedwithlukewarmwaterand
repeatthevacuum-formingprocess.
•Makesurethattheconnectiontubeisproperlyconnectedtoboththecontainerknoband
the air inlet(4) of the appliance.
•Makesurethatthegasketofthecontainercaportheuniversalcapissetproperlyinplace
andisnotdamaged.
•Whentherstvacuumphasestartsgentlypressdownthecapontothecontaineruntilthe
vacuumgaugepointerbeginstoturn.
TROUBLESHOOTING

Table of Contents

Related product manuals