EN
Installing the Batteries in the Remote Control
Install 2 AAA (1.5V) batteries matching the polarity indicated
nside battery compartment of the Remote Control
Incorrect use of batteries can result in hazards such as leakage
and bursting. Please observe the following
es are
not recommended to use for Remote Control
Do not mix different types of batteries such as alkaline
and standard (carbon-zinc)
Do not use different kinds of batteries together
lthough they may look similar, different batteries may have
Ends of each battery match
Remove batteries from battery compartment that is not
going to be used for a month or more
When disposing of used batteries, please comply with
governmenta
s rules that apply in your country or area
Using the Remote Control
Keep in mind the following when using the Remote Contro
e
Remote Control and the infrared sensor window on the
un
ou need to set both the unit and the Remote Control
o the same Code. (The default setting for the Remote
ontrol is “Code1”) Refer to page 58 for more
nformation on Remote Control Code
Remote operation may become unreliable if Strong
sunlight or fluorescent light is shining on the infrared
sensor w
Remote Controls for different devices can interfere with
each other. Avoid using Remote Controls from othe
evices which are located Close to the unit
Replace the batteries when you notice a fall off in the
operating range of the Remote Control
he maximum operable ranges from the unit are as
follows
Either side of the center
approx. 16 feet (5m) within 30°
approx. 16 feet (5m) within 15°
approx. 10 feet (3m) within 30°
30˚30˚
23 feet (7m)
If using a universal remote, please check for any additional
remote Code or contact the manufacturer for additional
ass
annot guarantee about third party’s Remote Controls.
lease contact the remote manufacturer if you have any
pro
o check if the Remote Control is working please check on
EN.indd13 2015/09/0219:00:28