Magnetrol eclipse Enhanced Model 705 User Manual

36
57-642 ECLIPSE Model 705 Guided Wave Radar Transmitter for Hygienic Industries
5.2 Status Messages
Display Message Action Comment
Lo Temp Present temperature in
electronics compartment is
below -40° C
1) Transmitter may need to be moved to ensure ambient temperature
is within specification
2
) Change to remote mount transmitter
HiVolAlm Level more than 5% above
highest point in strapping table
Verify strapping table is entered correctly.
Sys Warn Unexpected but non-fatal
software event
Consult factory
T
rimReqd
F
actory set Loop values are
defaults, loop output may be
inaccurate
C
onsult factory
Cal Reqd Factory set default calibration
parameters are in use, level
reading may be inaccurate
Consult factory
SlopeErr Ramp circuit generating
improper voltage
Consult factory
LoopFail Loop current differs from
expected value
Consult factory
No Ramp No End-of-Ramp signal detected Consult factory
DfltParm Internal non-volatile parameters
have been defaulted
Consult factory
LVL < Probe
Length
Apparent position of the upper
level pulse is beyond the end of
probe.
1) Check entered probe length
2) Change threshold to fixed
EE Fail EEPROM error allowing watch-
dog timer to expire
Consult factory
CPU Fail A-D converter time out allowing
watchdog timer to expire
Consult factory
SfwrFail A fatal software error allowing
watchdog timer to expire
Consult factory
PACTware
™
PC Program
The ECLIPSE Model 705 offers the ability to do Trending and Echo Curve analysis using a PACTware DTM.
This is a powerful troubleshooting tool that can aid in the resolution of some of the Error Messages shown above.
Refer to Bulletins 59-101 and 59-601 for more information.

Magnetrol eclipse Enhanced Model 705 Specifications

General

Brand	Magnetrol
Model	eclipse Enhanced Model 705
Category	Transmitter
Language	English