EasyManua.ls Logo

Mahindra 4010 HST - Oil Drain Plug; Oil Filter; Remove with Filter Wrench; Replacing the Oil Filter

Mahindra 4010 HST
159 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
-6
DIESEL ENGINE
1
(1) Oil Drain Plug
051O601B
1. Replace oil lter with at least every
other oil change.
2. Remove the filter using a filter
wrench.
3.Apply a thin layer of clean oil to the
gasket on the new lter.
4. Screw the new filter on. Hand-
tighten only. If the gasket contacts
with the sealed place, fasten it
with hands. If you fasten it with
wrenches, the fastening force may
be greater than necessary.
3
2
(2) Oil Filter
(3) Remove wiht filter wrench(Hand-tighten
only)
051O602B
5. The level of engine oil is lowered
when replacing cartridges. So,
check whether any oil leakage is in
sealed places when operating the
engine for a while, and then check
the oil level. If necessary, replenish
oil.
Swipe off any engine oil stained
on the machine.
REPLACING THE OIL FILTER
NOTE

Table of Contents

Related product manuals