Mahindra 4010 HST - Hydraulic Oil Filter and Engine Oil Filter Cartridge; Changing the Coolant

►
►
►
► CHANGING THE COOLANT
(1) Open the tap in front of the gear pump to drain the coolant.
(2) Open the radiator cap at the same time.
(3) To give a thorough clean run a hose into the radiator and flush it out.
(4) Close the tap and refill the radiator with a coolant mixture of water and corrosion inhibitor
or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes, check the water level again and top up
if required
Do not remove the radiator cap on a hot engine.
Allow the engine to cool down and then turn the cap slowly to ensure, that
there is no excessive pressure in the radiator.
Caution
Serious burns, can result from the contents of pressurized, hot radiators.
Allow the engine to cool down completely before opening radiator cap.
Caution
►
►
►
► HYDRAULIC OIL FILTER AND ENGINE OIL FILTER CARTRIDGE
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by
hand until seal contacts bare, then turn it 2/3
rd
turn
further to tighten it check for leaks.
68