Mahindra 4010 HST User Manual

6
-7
TROUBLESHOOTING
z
If the engine does not start or run properly, refer to the following charts to determine the cause
and identify corrective actions.
z
If the cause cannot be determined, contact your DAEDONG dealer for assistance.
ENGINE OVERHEATS
Possible causes Actions
Low coolant level
•
Check for and repair leaks. Add coolant.
Loose or broken fan belt
•
Adjust or replace belt as required.
Low oil level
•
Add water or replace coolant to achieve proper mix.
Anti-freeze concentration too high
•
Clean dirt and debris from radiator core and radiator guard.
Cooling air obstructed
•
Flush and clean system. Replace parts as required.
Cooling system dirty or corroded
•
Flush and clean system. Replace parts as required.
Defective radiator cap
•
Replace defective cap.
Faulty thermostat
•
Check and replace thermostat nd replace, if necessary.
Defective temperature gauge or send-
ing unit
•
Calibrate using thermometer and replace, if necessary.
Engine overload
•
Reduce load.
Leaking head gasket
•
Replace head gasket.
Fuel injection timing
•
Check and adjust timing.
Unsuitable fuel
•
Replace fuel with the clean fuel of the proper type and grade.
NOTE

Mahindra 4010 HST Specifications

General

Brand	Mahindra
Model	4010 HST
Category	Front End Loaders
Language	English