Mahindra 4010 HST - Changing the Oils in the Tractor; Changing Engine Oil; Changing the Transmission Oil

Always use the same grade and specified oil as Replacements.
Dispose off the old oil as per local regulations.
When changing the oil always change the filter.
Always use the same oil, as using different oils or specifications can cause damage.
Dispose off the old oil as per local regulations.
►
►
►
► CHANGING THE TRANSMISSION OIL
1. Allow the transmission oil to cool.
2. Remove the drain plug from bottom of the transmission and drain the oil.
3. Replace and check the drain plug.
4. Refill the transmission to the correct level on the dipstick with new oil : Qty 35
ℓ (9.25 US gal)
►
►►
► CHANGING THE OILS IN THE TRACTOR
Always use quality oils as engine or transmission oil
Refer to the table on page 60 and 61 for the change frequency.
►
►►
► CHANGING ENGINE OIL
Park tractor on level surface, shut-off engine. Remove sump
plug & drain oil. Replace and check the sump plug and refill
he engine with oil to the correct level on the dipstick
(approx. 1.85 gal)
The grade of oil to be used will depend on
the ambient temperature.
The tractor is shipped from the factory with 15W/40.
For summer use over 77 ℉ use SAE 30
For temperatures from 32 ℉ -77 ℉ use SAE20 or 15W/40.
For temperatures below 32 ℉ use SAE 10W.
important
important
66