EasyManuals Logo

Mahindra 4010 HST User Manual

Mahindra 4010 HST
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
WARNING LIGHTS
Charge lamp
This light will go off as soon as the engine starts to run to indicate that the alternator is
changing. (Please note, as broken fan belt can cause the light to come on, please stop the
engine as overheating can occur if not rectified immediately)
Oil pressure lamp
Will go out as soon as the engine starts if the oil pressure is correct. If it comes on while
the engine is running, stop the engine and get expert advice.
PTO monitor Lamp
Shows the revolution of PTO
Refer to monitor lamp on Page 38.
High beam lamp is operated on the combination switch.
Low beam lamp is operated on the combination switch
Glow signal Lamp indicates preheating
Parking brake lamp is operated when footbrake is engaged.
4WD drive lamp is operated on when front-wheel drive is engaged.
Fuel Level : If it comes on while the engine is running, Fill the tank with fuel.
Cruise Control Lamp is operated on when cruise control is engaged.
Check lamp is operated when the key switch is set to ON position and a safety start
condition is not satisfied.
37

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mahindra 4010 HST and is the answer not in the manual?

Mahindra 4010 HST Specifications

General IconGeneral
BrandMahindra
Model4010 HST
CategoryFront End Loaders
LanguageEnglish

Related product manuals