Mahindra 4010 HST - Front Wheel Drive Lever; Drivers Seat; Operating the Safety Switch; Seat Belt

►
►
►
► FRONT WHEEL DRIVE LEVER (4WD)
The Differential Lock Pedal is located below the
LHS of the Operator.
In the ON position the front wheels are engaged and
in the OFF position they are disengaged.
Engage & disengage the front wheel drive with the
front wheels in the straight position and at low
Engine RPM.
Do not use front wheel drive at
high speed or on the road as
premature wear of components
will result.
Use of front wheel drive improves traction performance.
■
■
■
■ Seat Belt
-Release the Seat Belt
Press button C and Pull the Male Fitting A from the Buckle B.
-Adjusting the Seat Belt
Make Sure the belt is across your hip and not over your stomach.
To adjust the male fitting A :
1. Pull toggle D down the strap by the required distance.
a. To make the strap longer, pull end E as far as it will go.
b. To make the strap shorter, pull end F as far as it will go.
■
■
■
■ Operating the Safety Switch
If you do not sit the your seat when you operate the Tractor,
Engine will turn off.
►
►►
► DRIVER’S SEAT
To adjust the seat backwards and forwards lift the lever at
the front of the seat and set it to the desired position (Please refer to page 17 of how to adjust the seat)
important
Always stop the machine when
using the front wheel drive lever.
important
43