EasyManuals Logo

Mahindra 4010 HST User Manual

Mahindra 4010 HST
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
BLEEDING THE FUEL SYSTEM (
Fuel Filter)-
1. Raise the engine cover.
2. Make sure there is fuel in the fuel tank.
3. Make sure the fuel cock on the fuel filter is set to ON.
4. Open the fuel cock on the fuel injection pump.
5. Using the starter key, turn the engine until air free fuel
flows from the fuel cock on the fuel injection pump.
6. Close the fuel cock on the fuel injection pump.
7. The engine is now ready to start. If the engine runs
smoothly for a short time and then begins to run
roughly, leave at idle until it runs smoothly.
BLEEDING THE FUEL SYSTEM (
Fuel Filter)
1. Close the fuel cock.
2. Remove the fuel filter element.
3. Wash the fuel filter element in clean diesel fuel.
If necessary, replace it.
4. Fit cleaned or new fuel filter element
5. Open the fuel cock.
6. Bleed the fuel system
Never use petrol, thinners or any other similar inflammable material to clean the
fuel filter.
important
65
Fuel Filter Element

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mahindra 4010 HST and is the answer not in the manual?

Mahindra 4010 HST Specifications

General IconGeneral
BrandMahindra
Model4010 HST
CategoryFront End Loaders
LanguageEnglish

Related product manuals