Long-term storage.
When the tractor will not be used for a long time carry out the cleaning as for short term storage.
Drain the oil and replace with new oil.
Run the engine for approx. 5 min. to ensure that it has new oil throughout the engine.
Drain the coolant from the radiator and remove the ignition key.
Attach a tag both the key and the steering wheel saying” No coolant”.
Lubricate all grease and oil points on the tractor.
Check the pressures and add a small amount of extra pressure.
Lower any implement to the ground or store in a shady dry place.
Place a piece of wood under each tire to preserve the tire.
After refilling the engine with the coolant run the engine for approx. 5-10 min. at
1500-2000rpm every month as a corrosion prevention measure.
Either removes the battery or the negative terminal as mouse damage to wiring can cause
short circuits and fires.
Remove the ignition key and store in a safe place.
Re-use after long term storage.
Carry out a full check of all oils and coolant.
Refit the battery and run the engine at idle for 30 min. to ensure optimum engine life.
When washing the tractor ensure that the water does not get near electrical
components or the oil filter points.
To prevent short circuits remove the ignition key.
Do not wash the tractor when the engine is running.
MAINTENANCE
For daily or short term storage
Clean the tractor and remove all dirt from field work.
Fill the fuel tank to avoid condensation and rust.
Lower the implement to the ground..
Keep it in a machinery shed or, if not available cover the unit if left outside.
In very cold conditions it is advisable to remove the battery and keep it inside in a warm environment.
This will ensure effective starting when the tractor is required.
When the outside temperature is below 32
℉
, replace the Antifreeze completely or drain the coolant to
protect the engine from damage from frozen coolant.
important
important
75
To Next Page
Loading...
Need help?
General
