Manitou MAN'GO 12 User Manual

1 - 10
D - VISIBILITY
- Maintain permanently good visibility throughout the route. To increase your visibility, you can move forwards with the
pendular arm slightly raised (pay attention to the risk of falls in the basket from knocking into a low doorway, overhead
electric wires, travelling cranes, highway bridges, tracks or any obstacle in the area in front of the platform). In reverse,
look directly behind you. In any case, avoid reversing over long distances.
- If visibility of your road is inadequate, ask someone to help, standing outside the area in which the platform will be
moving, and make sure you always have a good view of this person.
E - STARTING THE PLATFORM
• PLATFORMS WITH IC ENGINES
SAFETY NOTICE
- Do not pull or push the lifting platform to start it. This type of manoeuvre would cause severe damage to the transmission. In
cases of necessity, towing requires that the lifting platform be placed in freewheeling mode (See chapter 3 - MAINTENANCE).
- If using an emergency battery for start-up, use a battery with the same characteristics and respect battery polarity when
connecting it. Connect at first the positive terminals before the negative terminals.
t
IMPORTANT
t
Failure to respect polarity between batteries can cause serious damage to the electrical circuit. The electrolyte in the battery may produce an explosive gas. Avoid flames
and generation of sparks close to the batteries.
Never disconnect a battery while it is charging.
INSTRUCTIONS
- Check the closing and locking of the hood(s).
- Turn the ignition key to notch I to switch on the electrical power, which automatically starts the pre-heating system (all
the bars must be displayed), the message “OK” is displayed.
- Check that everything is operating correctly by ensuring that no fault pages are displayed on the screen and no warning
about the fuel level
- (a pump icon is present on the screen)
- (see chapter 2 - DESCRIPTION, CHECKING AND CONTROL INSTRUMENTS pages).
- To start, turn the ignition switch to position I.
- Press the starter button.
- Do not engage the starter motor for more than 15 seconds and carry out the preheating for 10 seconds between
unsuccessful attempts.
- Check all control instruments when the I.C. engine is warm and at regular intervals during use, so as to quickly detect
any faults and to be able to correct them without any delay.
- If any faults are displayed on the screen, stop the engine and immediately take the necessary measures.
• ELECTRIC PLATFORMS
SAFETY NOTICE
- Do not use the platform if the battery is discharged to the point that movements are slowed down. In certain cases,
the platform may stop (see chapter 3 - MAINTENANCE : EVERY DAY OR EVERY 10 HOURS FOR OPERATION pages, for the
minimum permissible charge level).
INSTRUCTIONS
- Set the battery cut-out to the ON position.
- Check the closing and locking of the hood(s).
- Turn the ignition key to the basket position.
- Check that everything is operating correctly by ensuring that no error messages are displayed on the screen and that the
machine maintenance light is not flashing (see chapter 2 - DESCRIPTION, CHECKING AND CONTROL INSTRUMENTS pages).
NB: For machines not fitted with a display or a maintenance warning light, faults can be identified from the light directly
on the variable speed drive unit (to access: open the cowl on the control size, remove the casing from the variable speed
drive and see whether the light is flashing).
- If any error messages are constantly displayed or the machine maintenance light is flashing, return the key to the neutral
position.
- Set the battery cut-off to the OFFposition.
- Immediately take the necessary measures.
647533 (09/10/2015) MAN'GO 12

Manitou MAN'GO 12 Specifications

General

Brand	Manitou
Model	MAN'GO 12
Category	Boom Lifts
Language	English