Manitou MAN'GO 12 User Manual

C - EVERY 250 HOURS OF OPERATION
Perform the operations described above as well as the following operations.
C1 – WHEELS NUTS TIGHTENING
CHECK
Check the tightness of the wheel nuts: 25 daNm ± 10%
t
IMPORTANT
t
Failure to observe this instruction may cause the wheel pins to be damaged and break, as well as the wheels to deform.
C2 – EMERGENCY PUMP
CHECK
- Switch off the engine.
Check that the emergency pump is operating correctly by performing an arm lowering
for example.
t
IMPORTANT
t
You must not use the lifting platform under any circumstances if the pump is not working.
C3 – ADJUSTMENT OF THE TELESCOPE ARM
CHECK
Check the tightness of the four nuts 1 on the telescope skids in the telescop arm.
t
IMPORTANT
t
Failure to observe this instruction may result in loss of the skids and damage to the telescope.
C4 – LEVEL IN THE BRAKE REDUCER IN THE TURRET’S REDUCTION GEAR
CHECK
Set the platform on a horizontal surface with the engine switched off.
- Open the left hood of the turret.
- The reduction gear has the valve block towards the back.
- Remove the filling-sniffler cap 1.
- The level is correct when the sniffler is full of oil.
- If necessary, top up with a syringe, filling the reducer via the filling-sniffler cap.
- Refit the filling-sniffler cap 1.
3 - 18
1
1
1
1
1
647533 (09/10/2015) MAN'GO 12

Manitou MAN'GO 12 Specifications

General

Brand	Manitou
Model	MAN'GO 12
Category	Boom Lifts
Language	English