Manitou MAN'GO 12 User Manual

USING THE LIFTING PLATFORM
BEFORE STARTING THE LIFTING PLATFORM
Check the following levels:
• Engine oil
• Oil in the hydraulic reservoir
• Coolant
STARTING THE LIFTING PLATFORM
Turn the ignition key 1 to notch to make the electrical contact.
Press button 2 to start up the IC engine.
t
IMPORTANT
t
Do not operate the starter for more than 30 seconds and run a pre-heating cycle between all failed attempts
to start.
Release the button as soon as the engine starts and let the engine run at tickover
speed.
t
IMPORTANT
t
Never try to push or pull the lifting platform to start it. Such an action would cause severe damage to the
transmission.
MOVEMENT IN TRANSPORT / WORK MODE
Before moving or using the machine, remove the turret lock 1.
START
ENGINE
1
2
The lifting platform has two separate movement modes: Transport mode and Work
mode (direction of forward movement).
Transport mode: the lifting platform’s arms are in the Low position and the telescope
is retracted; the pendular arm may be raised completely. This mode enables you
to move at high speed and operate beyond the tilt limit of the machine (See the
CHARACTERISTICS section).
FORWARD
TRANSLATION
REVERSE
TRANSLATION
1
2 - 44
647533 (09/10/2015) MAN'GO 12

Manitou MAN'GO 12 Specifications

General

Brand	Manitou
Model	MAN'GO 12
Category	Boom Lifts
Language	English