Manitou MAN'GO 12 User Manual

1 - 15
WELDING ON THE ACCESS PLATFORM
- Disconnect the battery or batteries before welding on the platform.
- When carrying out electric welding work on the platform, connect the negative cable from the equipment directly to
the part being welded, so as to avoid high tension current passing through the alternator or the live ring.
- If the platform is equipped with an electronic control unit, disconnect this before starting to weld, to avoid the risk of
causing irreparable damage to electronic components.
t
IMPORTANT
t
Welding operations on the structure for maintenance or repair operations must only be performed by MANITOU-certified personnel.
WASHING THE PLATFORM
- Clean the platform or at least the area concerned before any intervention.
- Remember to close and lock all accesses to the platform (cowls…).
- When cleaning with a pressure washer, avoid the articulation joints, and the electrical components and connections.
- If necessary, protect components likely to be damaged, and in particular the electrical components (variable speed drive,
charger) and connections and the injection pump from penetration by water, steam or cleaning products.
- Dry the electrical components.
- Clean the platform of any fuel, oil or grease trace.
- Grease the shafts.
FOR ANY INTERVENTION OTHER THAN REGULAR MAINTENANCE, CONSULT YOUR DEALER.
647533 (09/10/2015) MAN'GO 12

Manitou MAN'GO 12 Specifications

General

Brand	Manitou
Model	MAN'GO 12
Category	Boom Lifts
Language	English