EasyManuals Logo

Manitou MC 18-2 D K ST5 S1 User Manual

Manitou MC 18-2 D K ST5 S1
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
INSTRUCTIONS TO THE COMPANY MANAGER
THE SITE
- Proper management of the lift truck's area of travel will reduce the risk of accidents:
• Ground not unnecessarily uneven or obstructed,
• No excessive slopes,
• Pedestrian traffic controlled, etc.
THE OPERATOR
- Only qualified, authorised personnel can use the lift truck. This authorisation is given in writing by the appropriate person
in the establishment with respect to the use of lift trucks and must be carried permanently by the operator.
IMPORTANT
Experience has shown that there are a number of inappropriate ways in which the lift truck might be used. Such foreseeable misuse, of which the main examples are listed
below, are strictly forbidden.
- The foreseeable abnormal behaviour resulting from ordinary negligence, but which does not result from any wish to put the machinery to any improper use.
- The reflex reactions of a person in the event of a malfunction, incident, fault, etc. during operation of the lift truck.
- Behaviour resulting from application of the "principle of least effort" when performing a task.
- For certain machines, the foreseeable behaviour of such persons as: apprentices, teenagers, handicapped persons, trainees tempted to drive a lift truck, operators
tempted to operate a truck for the purposes of a bet, a competition or for their own personal experience.
The person in charge of the equipment must take these criteria into account when assessing the suitability of a person to drive.
THE LIFT TRUCK
A - THE TRUCK'S SUITABILITY FOR THE JOB
- MANITOU has ensured that this lift truck is suitable for use under the standard operating conditions defined in this
operator's manual, with a STATIC TEST COEFFICIENT OF 1.33 and a DYNAMIC TEST COEFFICIENT OF 1, as specified in
harmonised standard ISO 3691-1 for mast trucks.
- Before commissioning, the company manager must make sure that the lift truck is appropriate for the work to be done,
and perform certain tests (in accordance with current legislation).
B - ADAPTATION OF THE LIFT TRUCK TO STANDARD ENVIRONMENTAL CONDITIONS
- In addition to series equipment mounted on your lift truck, many options are available, such as: road lighting, stop lights,
revolving light, reverse lights, reverse buzzer alarm, front light, rear light, etc.
- The operator must take into account the operating conditions to specify the lift truck's signalling and lighting equipment.
Contact your dealer.
- Take the climatic and atmospheric conditions of the site of use into account.
• Protection against frost (
3-MAINTENANCE).
• Adaptation of lubricants (ask your dealer for information).
• Engine filtration (
3-MAINTENANCE).
IMPORTANT
For operation under average climatic conditions, i.e.: between -15 °C and +35 °C, correct levels of lubricants in all the circuits are checked in production.
For operation under more severe climatic conditions, before starting up, it is necessary to drain all the circuits, then ensure correct levels of lubricants using lubricants
properly suited to the relevant ambient temperatures.
The same applies to the cooling liquid.
- Preventing fire risks associated with use in dusty and flammable conditions (e.g. straw, flour, sawdust, organic waste, etc.).
- A lift truck operating in an area without fire extinguishing equipment must be equipped with an individual extinguisher.
There are solutions, consult your dealer.
IMPORTANT
Your lift truck is designed for outdoor use under normal atmospheric conditions and indoor use in suitably aerated and ventilated premises.
It is prohibited to use the lift truck in areas where there is a risk of fire or which are potentially explosive (e.g. Refineries, fuel or gas depots, stores of flammable products,
etc.).
For use in these areas, specific equipment is available (ask your dealer for information).
1 - 6
647837 M1 (A052020)
MC 18-2/18-4 D K ST5 S1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MC 18-2 D K ST5 S1 and is the answer not in the manual?

Manitou MC 18-2 D K ST5 S1 Specifications

General IconGeneral
BrandManitou
ModelMC 18-2 D K ST5 S1
CategoryForklifts
LanguageEnglish

Related product manuals