Manitou MC 18-2 D K ST5 S1 User Manual

CHECK Coolant level
Place the lift truck on level ground with the engine stopped, and allow the engine to cool.

IMPORTANT

To avoid any risk of spraying or scalding, wait until the engine has cooled down before removing the cooling system
filler plug.
In the event of an emergency, it is possible to use water as the coolant, but then proceed to drain the coolant circuit as
quickly as possible.
- Open the engine cover (2-DESCRIPTION-INSTRUMENTS AND CONTROLS).
- The liquid must be at the MAX. level on the expansion tank1.
- If necessary, add coolant (LUBRICANTS AND FUEL) through the filler hole2.
- Check for leaks.
CLEAN Cyclonic pre-filter (OPTION)
The cleaning interval is given as a guide, however the pre-filter must be emptied and
cleaned as soon as impurities reach the MAX level on the tank.

IMPORTANT

When cleaning, take care not to let impurities into the dry air filter.
- Loosen nut1 remove cover2 and empty the tank.
- Clean the pre-filter unit with a clean dry cloth and reassemble the unit.
1
2
3 - 13
1
2
647837 M1 (A052020) MC 18-2/18-4 D K ST5 S1

Manitou MC 18-2 D K ST5 S1 Specifications

General

Brand	Manitou
Model	MC 18-2 D K ST5 S1
Category	Forklifts
Language	English