Âp
2000H-PERIODIC SERVICE-EVERY 2,000 HOURS OF SERVICE OR 4 YEARS
ALSO PERFORM THE 500 HOUR AND 1000 HOUR PERIODIC MAINTENANCE OPERATIONS.
CHECK Wheel nut tightening torque
- Check the condition of the tyres to detect cuts, blisters, wear, etc.
- Check the tightening torque of the wheel nuts with a torque wrench.
• Front wheels=550 N.m ±55 N.m
• Rear wheels=110 N.m ±16 N.m
MC . . -2
• Rear wheels=200 N.m ±20 N.m
MC . . -4
REPLACE Dry air filter safety cartridge
IMPORTANT
The safety cartridge replacement frequency is given for information only. It must be changed every second time the
dry air filter cartridge is changed.
- For the dismantling and refitting of the cartridge (1000H: REPLACE Air filter
cartridge).
- Remove the dry air filter safety cartridge1 carefully, to minimise dust fall.
- Clean the gasket surface on the filter with a damp, clean lint-free cloth.
- Before fitting, check the condition of the new safety cartridge (FILTER CARTRIDGES
AND BELTS).
- Introduce the safety cartridge into the filter axis, pressing on the edges and not
the middle.
REPLACE Hydraulic oil
CLEAN Hydraulic oil tank suction strainer *
REPLACE Hydraulic oil tank filter cap
Place the lift truck on level ground with the engine stopped, the mast tilted backward
and lowered as far as possible.
IMPORTANT
Thoroughly clean the area surrounding the drain plug and the hydraulic tank access hatch.
Dispose of the drain oil in an ecological manner.
Use a very clean container and funnel and clean the underside of the oil drum before filling.
- Open the engine cover (2-DESCRIPTION-INSTRUMENTS AND CONTROLS).
DRAINING THE OIL
- Place a container under drain plug1 and unscrew the plug.
- Remove level and filling plug2 to ensure that the oil is drained properly and discard.
- Allow the hydraulic tank to empty completely.
CLEANING THE SUCTION STRAINER
- Consult your dealer.
3 - 30
1
1
2
3
A
647837 M1 (A052020)
MC 18-2/18-4 D K ST5 S1
To Next Page
Loading...
Need help?
General