FILLING WITH OIL
- Clean and refit the drain plug1 (tightening torque73-97 N.m).
- Fill up with oil (LUBRICANTS AND FUEL) through filler hole3.
- Check the oil level on the dipstick 4, the oil level should be level with the red point.
- Check for any possible leaks at the drain plug.
FILTER PLUG REPLACEMENT
- Replace filler plug with a new filler plug 2 (
FILTER CARTRIDGES AND BELTS).*
Consult your dealer.
HYDRAULIC CIRCUIT DECONTAMINATION
- Let the engine run (accelerator pedal at mid position) for 5 minutes without using
any accessories on the lift truck, then for 5 more minutes while using all the hydraulic
movements (except the steering system and the service brakes).
- Accelerate the engine at full speed for 1 minute, then activate the steering system
and the service brakes.
- This operation allows the circuit to be decontaminated by the hydraulic oil filter.
IMPORTANT
It is sometimes necessary to bleed the circuits at the pump inlet when an air bubble forms during draining.
Then consult your dealer.
CHECK Radiator *
CHECK Transmission pressures *
CHECK Steering *
CHECK Steering swivel joints *
CHECK Rear axle *
CHECK Condition of mast assembly *
CHECK Mast lifting chains *
CHECK Mast rollers *
CHECK Condition of hoses and flexible pipes *
CHECK Condition of cylinders (leakage, rods) *
CHECK Hydraulic circuit pressures *
CHECK Bearings and bushings *
* Consult your dealer.
3 - 31
4
647837 M1 (A052020)
MC 18-2/18-4 D K ST5 S1