Âo
1000H-PERIODIC SERVICE-EVERY 1,000 HOURS OF SERVICE OR 2 YEARS
ALSO CARRY OUT THE PERIODIC MAINTENANCE FOR 500 HOURS OF SERVICE.
CHECK Seat belt
IMPORTANT
It is forbidden to use the lift truck if the seat belt is defective (fixing, locking, cuts, tears, etc.).
Immediately repair or replace the seat belt.
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:
• Fixing of the anchoring points on the seat.
• Cleanness of the strap and the locking mechanism.
• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:
• The correct winding of the belt.
• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.
NOTE: Following an accident, the seat belt must be replaced.
CLEAN Fuel tank
Place the lift truck on level ground with the engine stopped.
IMPORTANT
While carrying out these operations, do not smoke or work near a flame.
Never try to carry out a weld or any other operation by yourself, this could provoke an explosion or a fire.
- Inspect the parts of the fuel circuit and the tank liable to leak, both visually and
by touch.
- In the event of a leak, contact your dealer.
- Place a container under the drain plug 1 and unscrew it.
- Remove the filler plug2 to ensure correct drainage.
- Rinse with ten litres of clean diesel through the filler hole(3).
- Refit and tighten the drain plug1 (tightening torque 73-97 N.m).
- Fill the fuel tank with clean, filtered diesel.
- Turn on the lift truck's ignition to bleed air from the circuit.
NOTE: If necessary, activate the pump by hand 4 to facilitate starting of the engine.
3 - 26
1
2
3
4
647837 M1 (A052020)
MC 18-2/18-4 D K ST5 S1
To Next Page
Loading...
Need help?
General