Manitou MT 733 EASY 75D ST5 S1 User Manual

Ü
50H-WEEKLY SERVICE OR EVERY50 HOURS OF SERVICE
CHECK Tyre pressures
CHECK Wheel nut tightening
t
IMPORTANT
t
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Follow the recommended tyre pressures.
- Check the wheel nut tightening. Non-compliance with this instruction can lead to deterioration and breakage of the
wheel bolts and distortion of the wheels.
- Check and restore tyre pressures if necessary (e2-DESCRIPTION: TYRES).
NOTE: There is an OPTIONAL wheel tool kit.
CHECK Front axle differential seal
CHECK Rear axle differential seal
Place the lift truck on level ground with the engine stopped.
- Visually check that there is no leakage or seepage.
- If there is any leakage or seepage, check the level:
• Remove the level plug1, the oil should be flush with the edge of the hole.
• If necessary, add oil (
eLUBRICANTS AND FUEL) through the filler hole2.
• Refit and tighten the level plug (tightening torque34-49 N.m).
CHECK Gear box oil level
Park the lift truck on level ground with the boom raised, the engine stopped. Carry out
the check within5 minutes of the engine being stopped.
t
IMPORTANT
t
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (e1-INSTRUCTIONS AND SAFETY
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
- Remove the plastic cap1.
- Pull out dipstick2.
- Wipe the dipstick and check the correct level between the two MIN and MAX marks.
- If necessary, add oil (e1000H: REPLACE Gear box oil).
- Visually check that there is no leakage or seepage.
CHECK Front wheel reducer seals
CHECK Rear wheel reducer seals
Place the lift truck on level ground with the engine stopped.
- Visually check that there is no leakage or seepage.
- If there is any leakage or seepage, check the level:
• Place level plug1 in a horizontal position.
• Remove the level plug; the oil should be flush with the edge of the opening.
• If necessary, add oil (
eLUBRICANTS AND FUEL) by the same hole.
• Refit and tighten the level plug (tightening torque34-49 N.m).
3 - 16
1
2
2
1
1
647776 (28/02/2020) MT 733/933/1033 EASY 75D ST5 S1
www.duma-rent.com

Manitou MT 733 EASY 75D ST5 S1 Specifications

General

Brand	Manitou
Model	MT 733 EASY 75D ST5 S1
Category	Trucks
Language	English