CHECK Hydraulic oil level
Place the lift truck on level ground with the engine stopped, and the boom retracted
and lowered as far as possible.
t
IMPORTANT
t
Use a clean funnel and clean the underside of the oil drum before filling.
- Check dipstick1, the correct level must be at the level of the red dot.
- If necessary, add oil (eLUBRICANTS AND FUEL).
- Remove the cap2.
- Add oil through filler port2.
- Refit the cap.
- Visually check that there is no leakage or seepage.
CHECK Windscreen washer liquid level
Place the lift truck on level ground.
- Loosen screw 1 and lift up the brake fluid and windscreen washer tank access panel 2.
- Visually check the level in the tank.
- If necessary add windscreen washer fluid (
eLUBRICANTS AND FUEL).
- Remove the cap3.
- Add windscreen washer liquid through filler port.
- Refit the cap.
CLEAN Radiator cores
t
IMPORTANT
t
In a polluting atmosphere, clean the radiator cores every day.
Do not use a water jet or high pressure steam as this could damage the fins.
- Open the engine cover.
- If necessary, clean the intake grille on the engine bonnet.
- Using a soft cloth, clean the radiator cores in order to remove as much dirt as possible.
- Clean the radiator using a compressed air jet aimed from the engine towards
the radiator, in the opposite direction to the cooling air flow.
3 - 18
3
1
2
3
1
2
To Next Page
Loading...
Need help?
General
