Ü
250H-PERIODIC SERVICE - EVERY 250 HOURS OF SERVICE
CHECK Angle gear box oil level
Park the lift truck on level ground with the boom raised and the engine stopped.
t
IMPORTANT
t
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (e1-INSTRUCTIONS AND SAFETY
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
- Pull out dipstick1.
- Wipe the dipstick and check the correct level between the two MIN and MAX marks.
- If necessary, add oil (e1000H: REPLACE Angle gear box oil).
- Visually check that there is no leakage or seepage.
CHECK Parking brake
Place the lift truck on a slope of at least15% with the rated load in the transport position.
- Check the tightening adjustment by locking the parking brake in position A.
- The adjustment is correct when the lift truck remains stationary on the slope.
- Adjust if necessary.
- Press the brake pedal, then release the parking brake in position B.
- Progressively tighten the end of the lever 1 and recheck braking.
- Repeat the operation until the correct braking adjustment is obtained.
CLEAN Heating block check valve
- Since one-way valve 1 is located under the cab, it is possible for it to become
obstructed with spattered mud for example. Clean if necessary.
3 - 22
1
1
A
B
1
To Next Page
Loading...
Need help?
General
