Main screen.
To set the time, short press to increment the value or hold down
to move to the next number.
Daily hour meter screen.
Reset to zero.
Engine fault screen.
Fault code display.
ECU fault screen.
Fault code display.
Instantaneous consumption screen.
Countdown to next regeneration screen (700h => 0h).
Main screen.
HELP SCREENS
Self-cleaning fan, these screens are displayed for 3 seconds.
WARNING SCREENS
This screen is displayed for 3 seconds every 10 minutes in the event that there is water in the diesel. Drain
the fuel pre-filter (e3-MAINTENANCE: 10H-DAILY OR EVERY 10 HOURS OF SERVICE).
ENGINE PREHEAT INDICATOR LAMP
Preheat is necessary. When the lift truck is switched on, the indicator lamp comes on for 2seconds and goes off as soon
as preheat is ended. Start the lift truck’s engine.
ENGINE FAULT INDICATOR LAMP
If the indicator lamp comes on or flashes while the lift truck is in operation, a diagnostic fault has been detected. The lift truck
will operate in reduced mode. Consult your dealer without delay.
STOP
CUT-OFF ENGINE INDICATOR LAMP
If the indicator lamp lights up or flashes, when the lift truck is running, stop the engine immediately and consult your dealer.
STEERING SYSTEM OIL PRESSURE WARNING INDICATOR LAMP
If the indicator lamp lights up when the lift truck is running, stop the engine immediately and determine the cause (possible
leak, etc.).
2 - 39
To Next Page
Loading...
Need help?
General
