Manitowoc MAX-ER 16000 - Rigging Winch Operation; Selecting Rigging Winch Mode; Operating Rigging Winch; Free-Wheel Operation

Reference Only
Manitowoc Published 04-17-17, Control # 067-11 4-89
16000 HANGING MAX-ER® OPERATOR MANUAL SET-UP AND INSTALLATION
4
RIGGING WINCH OPERATION
If your crane is equipped with the optional rigging winch
(Drum 0) see the Rigging Winch Assembly drawing at the
end of this section for wire rope routing.
Selecting Rigging Winch Mode
See Figure 4-48 and Figure 4-49 in the following procedure.
TO TURN RIGGING WINCH MODE ON —
1. Go to Function Mode screen in main display.
2. In level 2, use the select buttons to enter selected drum
screen options. Select rigging winch data box
(Figure 4-48
).
NOTE: The rigging winch data box will only appear if this
feature is available.
3. In level 3, enter data box and use the select buttons to
turn ON rigging winch.
4. The yellow box with “I” icon appears when winch is ON.
5. Drum 4 handle (boom hoist) will now control the rigging
winch (Drum 0). “0” will appear in the indicator at the
boom hoist handle.
TO TURN RIGGING WINCH MODE OFF —
1. Go to Function Mode screen in main display.
2. In level 2, use the select buttons to enter selected drum
options screen. Select rigging winch data box
(Figure 4-48
).
3. In level 3, enter data box and use the select buttons to
turn OFF rigging winch.
NOTE: The rigging mode will automatically turn OFF when
power to the control system is turned off.
Operating Rigging Winch
Free-Wheel Operation
The winch has a free-wheel clutch which allows the drum
barrel to be disconnected from the drive mechanism. This
position allows the drum to turned by hand.
TO TURN FREE-WHEEL ON —
1. Pull out locking pin (1) and hold.
2. Pull out knob (2).
3. Release locking pin (1).
TO TURN FREE-WHEEL OFF —
1. Pull out locking pin (1) and hold.
2. Push knob (2) in.
3. Release locking pin (1).
Power Operation
1. Engage free-wheel feature.
2. Turn on rigging winch mode.
3. Pay out rigging line by moving Drum 0 control handle
forward.
4. Reeve rigging line through block and boom point and
connect to desired load line as shown in Rigging Winch
Assembly drawing at the end of this section.
5. Use engine throttle to snug up rigging line prior to paying
out load line from selected load drum. Faulty operation
will result if there is slack in rigging line before engaging
automatic part of operation.
FIGURE 4-48
Rigging Winch Mode
ON
OFF
FIGURE 4-49
1
Disengage
Free-Wheel
ON
2
Item Description
1 Locking Pin
2Knob
P2314