Manitowoc MAX-ER 16000 - General; MAX-ER Sensors; Boom Angle Indicator Calibration

Reference Only
Manitowoc Published 04-17-17, Control # 067-11 6-1
16000 HANGING MAX-ER® OPERATOR MANUAL MAINTENANCE
6
SECTION 6
MAINTENANCE
GENERAL
This section contains maintenance and adjustment
instructions for the limit devices on the Hanging MAX-ER
Attachment.
For maintenance and inspection of the following
components, see the Service Manual supplied with your
crane:
• Straps
• Wire Rope
• Load Block and Weight Ball
• Boom and Jib
MAX-ER SENSORS
The following sensors (Figure 6-1) are preset at the factory
and do not require adjustment or calibration:
• Counterweight lifting cylinder pressure sensors
• Counterweight lifting cylinder position sensor
BOOM ANGLE INDICATOR CALIBRATION
An angle sensor is located inside the node controller
mounted on the boom top and on the luffing jib top.
The boom and luffing jib angles are calibrated automatically
by the crane’s programmable controller as part of the rated
capacity indicator’s calibration procedure. See Rated
Capacity Indicator/Limiter (RCL) Operation Guide located in
Operator Information Manual in operator’s cab.
Item Description
1 Counterweight Lifting Cylinder
2 Pressure Sensor – Retract
3 Pressure Sensor – Extend
4 Position Sensor
FIGURE 6-1
2
1
3
1
4
P2426
Top View
P2427
Bottom View