Manitowoc MAX-ER 16000 - Calibrate Mast Stop with Position Sensor; Perform Pre-Raising Checks

Reference Only
SET-UP AND INSTALLATION 16000 HANGING MAX-ER® OPERATOR MANUAL
4-18
Published 04-17-17, Control # 067-11
Calibrate Mast Stop with Position Sensor
Calibrate the mast stop, as follows, before the mast is raised
to the point that the mast stops contact the mast stop pins on
the rotating bed.
NOTE The MAX-ER mast stop position information
screen will not be available with crane software
version M002066 or newer. Position Sensor
calibration will not be required.
NOTE Best results are obtained when the yoke on the
mast stop is below horizontal.
1. On the main display in the crane cab, select the mast
stop box in the information screen (see Figure 4-10
).
2. Press the enter button (red down arrow) on the display
touch pad to turn the border GREEN around the mast
stop box.
3. Press the confirm button (purple star) on the display
touch pad. The dimension in the mast stop should turn to
either 1 ft (0,305 m).
4. Press the exit button (red up arrow) on the display touch
pad to turn the border BLUE around the mast stop box.
Perform Pre-Raising Checks
Perform the following pre-raising checks and correct any
defects before raising fixed mast.
 Crane on firm, level surface
 Mast shims installed
 Mast inserts installed in proper sequence
 Mast and counterweight straps pinned in working
position
 All insert connector pins installed and properly retained
 Hanging MAX-ER set-up mode selected in RCL
 Live mast arms fully lowered
 All blocking, tools, and other items removed from mast
 Mast and boom hoist wire rope spooled tightly onto
drums and engaged with proper sheaves
 Equalizer securely attached to proper size assist crane.
and positioned at proper distance from end of mast
 Wind within allowable limits for operation
1.000 FT
OR
0.305 M
FIGURE 4-10
Mast Stop Box with
Green Border
Information Screen