OPERATOR AND SERVICE MANUAL
This Manual has been prepared for and is considered part of -
800D
This Manual is Divided into the following Sections:
INTRO INTRODUCTION AND TABLE OF CONTENTS
SECTION 1 SAFETY INFORMATION
SECTION 2 OPERATION
SECTION 3 MAINTENANCE
SECTION 4 LUBRICATION
SECTION 5 SERVICE
SECTION 6 REPAIR
SECTION 7 SIDE SHIMMING OF BOOM SECTIONS
SECTION 8 SPECIFICATIONS
SECTION 9 INSTALLATION
SECTION 10 CRANE INSTALLATION
SECTION 11 HOIST
SECTION 12 SCHEMATICS
NOTICE
The crane serial number is the only method your distributor or the factory
has of providing you with correct parts and service information.
The crane serial number is identified on the builder’s decal attached to the
crane frame. Always furnish crane serial number when ordering parts or
communicating service problems with your distributor or the factory.
An untrained operator subjects himself and others to death or
serious injury. Do not operate this crane unless:
• You are trained in the safe operation of this crane. National Crane is
not responsible for qualifying personnel.
• You read, understand, and follow the safety and operating
recommendations contained in the crane manufacturer’s manuals and
load charts, your employer’s work rules, and applicable government
regulations.
• You are sure that all safety signs, guards, and other safety features are
in place and in proper condition.
• The Operator Manual and Load Chart are in the holder provided on
crane.
DANGER
Published 5-27-2018 Control # 039-06
© 2018 Grove U.S. L.L.C.
Fo
r
Reference
Only
To Next Page
Loading...
