II Contents DKR Drive Controllers
DOK-DIAX03-DKR********-PR02-EN-P
Required distances for cooling with air from inside the cabinet............................................... 5-9
DKR02.................................................................................................................................... 5-10
DKR03.................................................................................................................................... 5-12
DKR04.................................................................................................................................... 5-14
DZB01....................................................................................................................................5-16
5.4 Additional dimensions when cooling with a duct.......................................................................... 5-17
5.5 Leads............................................................................................................................................ 5-20
5.6 Measures to avoid sources of interference in the control cabinet................................................ 5-22
6 Planning the electrical connections 6-1
6.1 Preliminary remark.........................................................................................................................6-1
6.2 Fundamental guidelines.................................................................................................................6-1
6.3 Positions of the connectors, pin configurations and lead cross sections.......................................6-2
6.4 Mains connection ........................................................................................................................... 6-4
Grounded three-phase systems ..............................................................................................6-4
Ungrounded three-phase system ............................................................................................ 6-5
6.5 Dimensioning .................................................................................................................................6-9
Mains fuses and lead cross sections....................................................................................... 6-9
Autotransformers ...................................................................................................................6-11
Isolating transformers ............................................................................................................6-12
Overvoltage suppressor......................................................................................................... 6-13
6.6 Functions and allocations of individual interfaces........................................................................6-14
X2: Serial interface.................................................................................................................6-14
X3: Analog output and signal contact ....................................................................................6-16
X4: Motor feedback................................................................................................................6-17
X6: Monitoring motor temperature and holding brakes .........................................................6-18
X7: Signal outputs..................................................................................................................6-19
X8: Signal voltages ................................................................................................................6-20
X9: Control inputs for internal power contactors.................................................................... 6-21
X5 and X10: Power voltage, control voltage and brake resistor connections .......................6-21
7 Accessories 7-1
7.1 Connector kits ................................................................................................................................ 7-1
Connector kit for the basic unit ................................................................................................7-1
Connector kit for all plug-in modules of a configuration including the feedback connections . 7-2
7.2 Fiber optic cables...........................................................................................................................7-3
7.3 Mechanical accessories.................................................................................................................7-4
Accessories for duct cooling ....................................................................................................7-4
Mounting frames ......................................................................................................................7-4
8 Transport and storage 8-1
8.1 Transport........................................................................................................................................8-1
8.2 Storage...........................................................................................................................................8-1
9 Identifying the merchandise 9-1
9.1 General...........................................................................................................................................9-1
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
