Manufacture Technology GEFXL2-CSW28KX - Ptp; 3-22.1 Configuration

Publication date: March, 2012
Revision A1
218
3-22 PTP
For Carrier Ethernet application that PTP is an acronym for Precision Time Protocol, a
network protocol for synchronizing the clocks of computer systems. The chapter describes the
user to configure and inspect the current PTP clock settings.
3-22.1 Configuration
This chapter allows the user to configure the PTP clock setting on the switch and the
parameters setting values.
Web Interface
To configure the PTP in the web interface:
1. Click Configuration, PTP then Configuration.
2. Scroll to select PTP External clock mode includes One_PPS_Mode, External Enable,
VCXO Enable.
3. Assign the clock frequency parameter.
4. Click “Add New PTP Clock” to create a new PTP entry.
4. Click the save to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
.
Figure 3- 22.1: The PTP Configuration
Parameter description:
 One_pps_mode:
This Selection box will allow you to select the One_pps_mode configuration.
The following values are possible: