Publication date: March, 2012
Revision A1
4-2.3 Dynamic Table
The section describes to configure the Dynamic ARP Inspection Table parameters of the
switch. The Dynamic ARP Inspection Table contains up to 1024 entries, and is sorted first by
port, then by VLAN ID, then by MAC address, and then by IP address.
Web Interface
To configure a Dynamic ARP Inspection Table Configuration in the web interface:
1. Specify the Start from port, VLAN ID, MAC Address, IP Address, and
entrie per page.
2. Checked “Auto-reflash”.
.
Figure 4-2.3: The Dynamic ARP Inspection Table
Parameter description:
Port :
Switch Port Number for which the entries are displayed.
VLAN ID :
VLAN-ID in which the ARP traffic is permitted.
MAC Address :
User MAC address of the entry.
IP Address :
User IP address of the entry.
Auto-refresh :
To evoke the auto-refresh icon then the device will refresh the information automatically.
Upper right icon (Refresh, <<, >> ):
You can click them for refresh the Dynamic ARP Inspection Table by manual, others for
next/up page or entry
To Next Page
Loading...