Publication date: March, 2012
Revision A1
4-1.3 Dynamic Table
The section describes to configure the Dynamic IP Source Guard Table parameters of the
switch. You could use the Dynamic IP Source Guard Table configure to manage the entries.
Web Interface
To configure a Dynamic IP Source Guard Table Configuration in the web interface:
1. Specify the Start from port, VLAN ID, IP Address, and entrie per page.
2. Checked “Auto-reflash”.
Figure 4-1.3: The Dynamic Table
Parameter description:
Port :
Switch Port Number for which the entries are displayed.
VLAN ID :
VLAN-ID in which the IP traffic is permitted.
IP Address :
User IP address of the entry.
MAC Address :
Source MAC address.
Auto-refresh :
To evoke the auto-refresh icon then the device will refresh the information automatically.
Upper right icon (Refresh, <<, >> ):
You can click them for refresh the Dynamic IP Source Guard Table by manual, others for
next/up page or entry.
To Next Page
Loading...