Manufacture Technology GEFXL2-CSW28KX - 4-2.2 Static Table

Publication date: March, 2012
Revision A1
230
4-2.2 Static Table
The section describes to configure the Static ARP Inspection Table parameters of the switch.
You could use the Static ARP Inspection Table configure to manage the ARP entries.
Web Interface
To configure a Static ARP Inspection Table Configuration in the web interface:
1. Click “Add new entry”.
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Save.
Figure 4-2.2: The Static ARP Inspection Table
Parameter description:
 Delete :
Check to delete the entry. It will be deleted during the next save.
 Port :
The logical port for the settings.
 VLAN ID :
The vlan id for the settings.
 MAC Address :
Allowed Source MAC address in ARP request packets.
 IP Address :
Allowed Source IP address in ARP request packets.
 Adding new entry :
Click to add a new entry to the Static ARP Inspection table. Specify the Port, VLAN ID,
MAC address, and IP address for the new entry. Click "Save".
 Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.