Publication date: March, 2012
Revision A1
5-2.2 Firmware Selection
Due to the switch supports Dual image for firmware redundancy purpose. You can select what
firmware image for your device start firmware or operating firmware. This page provides
information about the active and alternate (backup) firmware images in the device, and allows
you to revert to the alternate image.
Web Interface
To configure a Firmware Selection in the web interface:
1. Chick Activate Alternate Image.
2. Click yes to complete firmware selection..
Figure 5-2.2: The Firmware Selection
Parameter description:
Activate Alternate Image :
Click to use the alternate image. This button may be disabled depending on system state.
Cancel:
Cancel activating the backup image. Navigates away from this page.
Image :
The flash index name of the firmware image. The name of primary (preferred) image is
image, the alternate image is named image.bk.
Version :
The version of the firmware image.
Date :
The date where the firmware was produced.
To Next Page
Loading...