Publication date: March, 2012
Revision A1
4-7 Port Security
This section shows you to to configure the Port Security settings of the Switch. You can use
the Port Security feature to restrict input to an interface by limiting and identifying MAC
addresses.
4-7.1 Limit Control
This section shows you to to configure the Port Security settings of the Switch. You can use
the Port Security feature to restrict input to an interface by limiting and identifying MAC
addresses.
Web Interface
To configure a System Configuration of Limit Control in the web interface:
1. Select “Enabled” in the Mode of System Configuration.
2. Checked Aging Enabled.
3. Set Aging Period (Default is 3600 seconds).
To configure a Port Configuration of Limit Control in the web interface:
1. Select “Enabled” in the Mode of Port Configuration.
2. Specify the maximum number of MAC addresses in the Limit of Port
Configuration.
3. Set Ation (Trap, Shutdown, Trap & Shutdown)
4. Click Save.
Figure 4-7.1: The Port Security Limit Control Configuration
Parameter description:
System Configuration
Mode :
Indicates if Limit Control is globally enabled or disabled on the switchstack. If globally
disabled, other modules may still use the underlying functionality, but limit checks and
To Next Page
Loading...