Publication date: March, 2012
Revision A1
4-6.2 Radius Overview
This section shows you an overview of the RADIUS Authentication and Accounting servers
status to ensure the function is workable.
Web Interface
To configure a RADIUS Overview Configuration in the web interface:
1. Checked “Auto-reflash”.
Figure 4-6.2: The RADIUS Authentication Server Status Overview
Parameter description:
# :
The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address :
The IP address and UDP port number (in <IP Address>:<UDP Port> notation) of this server.
State :
The current state of the server. This field takes one of the following values:
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS
module is ready to accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it did not reply within
the configured timeout. The server has temporarily been disabled, but will get re-enabled
when the dead-time expires. The number of seconds left before this occurs is displayed in
parentheses. This state is only reachable when more than one server is enabled.
RADIUS Accounting Servers
# :
The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address :
The IP address and UDP port number (in <IP Address>:<UDP Port> notation) of this server.
State :
The current state of the server. This field takes one of the following values:
Disabled: The server is disabled.
To Next Page
Loading...