TSC 900 TRANSFER SWITCH CONTROLLER
PM 151 REV 1 15/10/08 Thomson Power Systems
5.3. ADMINISTRATOR PASSWORD MANAGEMENT PROCEDURE 46
5.4. SYSTEM TIME/DATE ADJUSTMENT 47
5.5. VOLTAGE CHANGE PROCEDURE 48
5.6. EXERCISE TIMER SETUP 49
5.6.1. ADDING NEW EXERCISE SCHEDULE EVENT 50
5.6.2. EDITING EXISTING EXERCISE SCHEDULE EVENT 50
5.7. PROGRAMMABLE INPUT MAPPING 51
5.8. PROGRAMMABLE OUTPUT MAPPING 54
5.9. SYSTEM SETTINGS 58
5.9.1. SYSTEM PHASES 58
5.9.2. SYSTEM VOLTAGE 58
5.9.3. SYSTEM FREQUENCY 58
5.9.4. PHASE ROTATION REVERSED 58
5.9.5. RATED GENERATOR POWER 59
5.9.6. CT RATIO (CURRENT TRANSFORMER) 59
5.9.7. PT RATIO (POTENTIAL TRANSFORMER) 59
5.9.8. LOAD NAME 59
5.9.9. SOURCE 1 (UTILITY) NAME 59
5.9.10. SOURCE 2 (GEN) NAME 59
5.9.11. APPLICATION MODEL 59
5.9.12. SWITCH OPERATION 59
5.9.13. SWITCH MODEL 60
5.9.14. TRANSFER SWITCH MECHANISM OPERATION TIME 60
5.10. OPTION SETTINGS 60
5.10.1. CURRENT METERING 60
5.10.2. GEN (SOURCE 2) COMMIT TO TRANSFER 60
5.10.3. ENABLE LOAD SHED ON UNDER FREQUENCY 60
5.10.4. ENABLE LOAD SHED ON OVER POWER 61
5.10.5. HALT OPERATION ON REVERSED SOURCE 61
5.10.6. ENABLE FAIL TO UNLOAD ALARM (CTTS MODEL 4) 61
5.10.7. TRIP UTILITY (SRC 1) WHEN CLOSED TRANSITION INHIBIT ACTIVATED 61
5.10.8. HALT TRANSFER ON FAIL TO EXTERNAL SYNC CHECK 61
5.10.9. MANUAL UTILITY RETRANSFER CONTROL 62
5.10.10. FORCE TRANSFER 62
5.10.11. GHC SLEEP MODE TIMEOUT 63
5.10.12. LOAD POWER METERING 63
5.10.13. MODBUS RTU 63
5.10.14. MODBUS TCP/IP 63
5.10.15. ENABLE SECURITY BYPASS 63
To Next Page
Loading...
Need help?
General