Mark-10 WT3-201M - Password Prompts

Model WT3-201M Motorized Wire Crimp Pull Tester User’s Guide
28
20.4 Password Prompts
If passwords have been enabled, the following will be displayed when pressing the MENU key or
accessing the Calibration section:
Use the UP and DOWN keys to select the correct password, then press ENTER to continue.
If the incorrect password has been entered, the display appears as follows:
To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and
enter the password again when prompted.
If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The
request code must be supplied to Mark-10 or a distributor, who will then provide a corresponding
authorization code. Enter the activation code to disable the password.
INCORRECT PASSWORD
Reset password
Request code:
XXXX
Press ENTER or ESC
ENTER PASSWORD
(0000 – 9999)
5000