Mark-10 WT3-201M - Initial settings; Restore Default Settings; Information; Welcome Screen

Model WT3-201M Motorized Wire Crimp Pull Tester User’s Guide
30
21.4 Initial settings
This section is used to configure the initial settings upon powering on the tester. The initial units of
measurement and the primary reading measurement mode may be configured. To access these settings,
select Initial Settings from the menu. The display appears as follows:
The default values are lbF and Real Time.
21.5 Restore Default Settings
Default factory settings can be restored by selecting Restore Defaults from the menu. The settings may
be found in the Specifications section. The display appears as follows:
21.6 Information / Welcome Screen
The following screen is displayed at power up and can be accessed at any time by selecting Information
from the menu:
Wire Terminal Tester
Series WT3M
Model No: WT3-201M
Serial No: 1234567
Version: 1.0
(c) Mark-10 Corp.
RESTORE DEFAULT
SETTINGS?
No
Yes
INITIAL SETTINGS
Units
lbF
Mode
Real Time