MARS COMMERCE GSW2 PLUS 1000 - Event Loging; Table 22: Entering SPIN Access Code Parameters; Table 23: Entering SPIN Access Codes Example

GSW2 PLUS EXT
INSTALLATION MANUAL
Page 33
SPIN access code from SPIN1 to SPIN50 will activate the relay output.
NOTE
Set the SPIN access entry codes active output first (disabled by default). ;SPINO=1;
8.12.1 SPIN1 to SPIN50
SPINx parameters are the temporary SPIN access codes for controlling the relay output. SPINCx
parameters are the determination, how many times SPINx code can be used.
8.12.2 Table of parameters
Name
Comment
SPIN1
SPIN access code 1.
SPIN2
SPIN access code 2.
…
SPIN50
SPIN access code 50.
Table 22: Entering SPIN access code parameters
Example:
 Direct programming on the SIM card
PROGRAMMING TABLE
Name
Number
Description
SPINO
1
SPIN Output is enabled.
SPIN8
5524
SPIN code 8
SPINC8
3
SPIN code 8 can be used 3 times
SPIN20
1234
SPIN code 20
SPINC20
1
SPIN code 20 can be used 1 time, then won’t be valid anymore
Table 23: Entering SPIN access codes example
 Remote programming by SMS
;SPINO=1;SPIN8=5524; SPINC8=3; SPIN20=5524; SPINC20=1;
Explanation: SPIN8 code 5524 can be used 3 times and after the 3th time it won’t be valid anymore.
And SPIN20 code 1234 can be used 1 time and after that time it won’t be valid anymore.
8.13 EVENT LOGING
GSW2 PLUS device supports logging of specific events. GSW2 PLUS logs CLIP event and alarm
input events.
Log event consist of event type, time and telephone number or input number.