MARS COMMERCE GSW2 PLUS 1000 - 9 Print-Out of the Parameters; Receive All Parameters (Pall); Check Wmod Settings (Pdewm); Check Sw Revision (Psw)

GSW2 PLUS EXT
INSTALLATION MANUAL
Page 36
9 PRINT-OUT OF THE PARAMETERS
The user can check the settings of ALL parameters on the GSW2 PLUS.
9.1 RECEIVE ALL PARAMETERS (PALL)
By sending this command to GSW2 PLUS you receive SMS messages with all parameters that are
currently programmed in the unit:
;PALL;
9.2 CHECK WMOD SETTINGS (PDEWM)
By sending this command to GSW2 PLUS you receive SMS messages with setting of WMOD
parameter:
;PDEWM;
9.3 CHECK SW REVISION (PSW)
By sending this command to GSW2 PLUS you receive SMS messages with current SW version
running on GSW2 PLUS device:
;PSW;
9.4 CHECK SIGNAL QUALITY (PSQ)
By sending this command to GSW2 PLUS you receive SMS messages with signal quality GSW2
PLUS device is connected to network:
;PSQ;
9.5 RECEIVE TELEPHONE NUMBERS (PTN)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed telephone numbers (TN1 – TN5):
;PTN;
9.6 RECEIVE LINKS (PLN)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed links (LN1 –LN7):
;PLN;
9.7 RECEIVE INPUT PARAMETERS (PIN)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed Input parameters (IN1 – IN2):
;PIN;