MARS COMMERCE GSW2 PLUS 1000 - Receive Input Filter Value (Pid); Receive Output Filter Value (Pod); Receive Delay before Dial Value (Pdd); Receive Access Telephone Numbers (Psl)

GSW2 PLUS EXT
INSTALLATION MANUAL
Page 37
9.8 RECEIVE INPUT FILTER VALUE (PID)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed Input filters (ID1 – ID2):
;PID;
9.9 RECEIVE OUTPUT FILTER VALUE (POD)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed direct output links (OD1 – OD4):
;POD;
9.10 RECEIVE DELAY BEFORE DIAL VALUE (PDD)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed Input filters (DD1 – DD4):
;PDD;
9.11 RECEIVE ACCESS TELEPHONE NUMBERS (PSL)
By sending this command to GSW2 PLUS you receive SMS message with programmed SL level:
;PSL;
9.12 RECEIVE OUTPUT PARAMETERS (POS)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed Outputs parameters (OS1 – OS2):
;POS;
9.13 RECEIVE OUTPUT PARAMETERS (POT)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed output time parameters (OTS1, OTE1, OTS2 and OTE2):
;POT;
9.14 RECEIVE ALL PROGRAMMED SMS MESSAGES (P#)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed alarm SMS messages (#0 - #2):
;P#;
9.15 RECEIVE SET UP PARAMETERS VALUE (PPA)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed Setup parameters (TST, MNF…):
;PPA;